Built for our most active customers, the L3 Clips are designed for use at the three Sync Bridle points which may see wear on the leading edge material of either the Djinn or Djuice with aggressive use. Once installed, the leading edge spar can still slide through easily with the bridle and leading edge material fully protected in those areas. These will also fit most other quad line kites with similar bridle attachments (frequently the center point). Check out the installation tutorial below!
This product has multiple variants. The options may be chosen on the product page
Replacement carbon spars for each frame component of the Gaze dual line kite, all pre-cut for easy installation.
This product has multiple variants. The options may be chosen on the product page
One ferrule, the joint used to connect the Radius spars in the Gaze leading edge (8cm) or bottom spreaders (12cm).
This product has multiple variants. The options may be chosen on the product page
One ferrule, solid fiberglass joint used to connect the Mystic spars in a Djinn leading edge.
This product has multiple variants. The options may be chosen on the product page
One 4" ferrule, solid fiberglass joint used to connect the Dynamic spars in a Djuice leading edge.
Angled fittings for the leading edge of the Gaze, connecting them to the upper and lower spreaders when assembled.
This product has multiple variants. The options may be chosen on the product page
Unique Yo Yo Stopper used on the Gaze leading edge, complete with one zip tie - designed to allow solid roll up tricks, additional notches allow a little forgiveness for overly slack lines.
