Object SUL Frame

Leading Edge: Dynamic T8 (72.5 cm | 2x 7 cm ferrule)
Bottom Spreaders: Dynamic T10 (65 cm | 1x 16 cm ferrule)
Spine: Dynamic T12 (80 cm)
Top Spreader: 5mm solid carbon (51 cm pre-cut)
Stand Offs: 3mm carbon (27 cm pre-cut, complete)

Object STD Frame

Leading Edge: Dynamic T12 (72.5 cm | 2x 7 cm ferrule)
Bottom Spreaders: Dynamic T15 (65 cm | 1x 16 cm ferrule)
Spine: Dynamic T12 (80 cm)
Top Spreader: 5mm solid carbon (51 cm pre-cut)
Stand Offs: 3mm carbon (27 cm pre-cut, complete)

Object VTD Frame

Leading Edge: Dynamic T12 (72.5 cm | 2x 7 cm ferrules)
Bottom Spreaders: Dynamic T15 (65 cm | 1x 16 cm ferrule)
Spine: Dynamic T12 (80 cm)
Top Spreader: 5mm solid carbon (51 cm pre-cut)
Stand Offs: 3mm carbon (27 cm pre-cut, complete)

Fitting Guide (parts can be found here – list is for a complete kite)

Most breakages in the field allow you to simple swap over the existing fittings onto replacement rods but if you wish to make a ready to install spare for your kite bag, these are the accompanying fittings for each spar:

Leading Edge
Upper – 2x Dynamic ferrule (7 cm), 2x upper spreader APA, 2x c-clip stopper, 2x vinyl end cap, 2x yo yo stopper (claw), 2x zip tie.
Lower – 2x lower spreader APA, 4x c-clip stoppers, 2x wing tip spike.
Bottom Spreaders – 1x Dynamic ferrule (16 cm) between two spreaders (glued into one side), 2x stand off fittings (one on each bottom spreader).
Spine – 1x center T fitting, 1x tail weight fitting, 2x c-clip stoppers, 1x vinyl end cap.

Our kites

Imports

Kites by type

How you fly

Lines & gear

Parts

Spars & framing

Products

Object Framing

Dynamic Spars (Djuice)

Mystic Spars (Djinn)

Dynamic Ferrule (Djuice)

Shop by category

Kites by type

How you fly

Lines & gear

Parts

Login

Register