Got a stuck ferrule? This does eventually happen toy everyone, but here’s a solution!
Mystic Ferrule (Djinn)
$1.50 – $2.00
One ferrule, solid fiberglass joint used to connect the Mystic spars in a Djinn leading edge.
Description
Additional information
Weight | .4 oz |
---|---|
Dimensions | 1 × 1 × 1 in |
Ferrule Type | Normal (Mystic 12-18), Light (Mystic 10) |
Related products
Unique Yo Yo Stopper used on the Gaze leading edge, complete with one zip tie - designed to allow solid roll up tricks, additional notches allow a little forgiveness for overly slack lines.
Vinyl end caps for the nose-end of the Gaze spine and upper leading edge spars.
Center T fitting used the bottom spreaders of the Gaze connect with the spine when assembled.
One ferrule, the joint used to connect the Radius spars in the Gaze leading edge (8cm) or bottom spreaders (12cm).
Run your dual line kites hard or still learning how to fly? The Gaze is tough but to be prepared for anything, use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. Recommendations below!
Package includes four aluminum end caps, four washer sets (8 pieces), four bungees (6” each) and two 4" cable ties, all you need to replace all four wingtips of a Djinn.
Angled fittings for the leading edge of the Gaze, connecting them to the upper and lower spreaders when assembled.
Need this for the leading edge center spar, You can use IC2000 glue or super glue.
I have not needed these yet, but it’s nice to know I have them if necessary.