APA Fittings
$2.50
Angled fittings for the leading edge of the Gaze, connecting them to the upper and lower spreaders when assembled.
Additional information
| Weight | .2 oz |
|---|---|
| Dimensions | 1 × 1 × 1 in |
| APA Size | Gaze STD – Upper LE / top spreader, Gaze STD – Lower LE / bottom spreader |
Reviews (0)
Related products
One ferrule, the joint used to connect the Radius spars in the Gaze leading edge (8cm) or bottom spreaders (12cm).
This product has multiple variants. The options may be chosen on the product page
Run your dual line kites hard or still learning how to fly? The Gaze is tough but to be prepared for anything, use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. Recommendations below!
Unique Yo Yo Stopper used on the Gaze leading edge, complete with one zip tie - designed to allow solid roll up tricks, additional notches allow a little forgiveness for overly slack lines.
Package includes four aluminum end caps, four washer sets (8 pieces), four bungees (6” each) and two 4" cable ties, all you need to replace all four wingtips of a Djinn.
Spike (or "nock") end cap used on the wing tip of the Gaze, complete with tensioner line - designed to provide good tip stabs even on firm earth or hard packed sand.
T fitting used at the bottom of the Gaze spine, complete with 15g + 5g weights.
Replacement carbon spars for the Djuice quad line kite (ST = D12 or VT = D15), each spar measures 31" in length and does not include ferrules.
This product has multiple variants. The options may be chosen on the product page
One set of three replacement Sync Bridle pigtails for the Djinn quad line kite, includes one center and two shoulder pieces that attach to the leading edge, these components take the most abuse (ground abrasion) and are also the easiest to replace.
Reviews
There are no reviews yet