One 4" ferrule, solid fiberglass joint used to connect the Dynamic spars in a Djuice leading edge.
Angled fittings for the leading edge of the Gaze, connecting them to the upper and lower spreaders when assembled.
This product has multiple variants. The options may be chosen on the product page
Center T fitting used the bottom spreaders of the Gaze connect with the spine when assembled.
Unique Yo Yo Stopper used on the Gaze leading edge, complete with one zip tie - designed to allow solid roll up tricks, additional notches allow a little forgiveness for overly slack lines.
Spike (or "nock") end cap used on the wing tip of the Gaze, complete with tensioner line - designed to provide good tip stabs even on firm earth or hard packed sand.
T fitting used at the bottom of the Gaze spine, complete with 15g + 5g weights.
Fittings for the bottom spreaders of the Gaze, connecting them to the stand offs when assembled. Sold individually.
Vinyl end caps for the nose-end of the Gaze spine and upper leading edge spars.
This product has multiple variants. The options may be chosen on the product page
Durable T-connector for the Djinn and Djuice quad line kites, used for the connection between vertical spars and the leading edge when assembled. Each kite uses two of these parts.
Package includes four plastic end caps, four washers, four bungees (6” each) and two 4" cable ties, all you need to replace all four wingtips of a Djuice.
Package includes four aluminum end caps, four washer sets (8 pieces), four bungees (6” each) and two 4" cable ties, all you need to replace all four wingtips of a Djinn.