Replacement process is simple – remove the old worn bungees, install the new, trim excess and carefully melt the cut end(s).
Bungee Set (Djinn)
$3.00
Four piece set of 6″ bungees, used on the outer and bottom wingtips of the Djinn, also includes two 4″ zip ties used on the outer wingtips.
Description
Additional information
Weight | .15 oz |
---|---|
Dimensions | 1 × 1 × 1 in |
Related products
Spike (or "nock") end cap used on the wing tip of the Gaze, complete with tensioner line - designed to provide good tip stabs even on firm earth or hard packed sand.
Run your dual line kites hard or still learning how to fly? The Gaze is tough but to be prepared for anything, use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. Recommendations below!
Run your Djinn hard or just learning how to fly? Use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. **
Vinyl end caps for the nose-end of the Gaze spine and upper leading edge spars.
Replacement carbon spars for the Djinn quad line kite, each spar measures 31" in length and does not include ferrules... If you are ordering a frame, be sure to also add 2 ferrules for every 5 spars to make a complete frame. (see full description to match spars to Djinn models)
Angled fittings for the leading edge of the Gaze, connecting them to the upper and lower spreaders when assembled.
One ferrule, the joint used to connect the Radius spars in the Gaze leading edge (8cm) or bottom spreaders (12cm).
Simple c-clip, glued on to keep APA and spine fittings in place on the Gaze.
Excellent, cut to the exact length. Takes the guess work out of replacing your bungies. Perfect for servicing your kite in the field