Stand Off Fittings
$2.50
Fittings for the bottom spreaders of the Gaze, connecting them to the stand offs when assembled.
Sold individually.
Additional information
| Weight | .2 oz |
|---|---|
| Dimensions | 2 × 1 × 1 in |
Reviews (0)
Only logged in customers who have purchased this product may leave a review.
Related products
T fitting used at the bottom of the Gaze spine, complete with 15g + 5g weights.
Run your Djinn hard or just learning how to fly? Use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. **
One ferrule, the joint used to connect the Radius spars in the Gaze leading edge (8cm) or bottom spreaders (12cm).
Unique Yo Yo Stopper used on the Gaze leading edge, complete with one zip tie - designed to allow solid roll up tricks, additional notches allow a little forgiveness for overly slack lines.
Angled fittings for the leading edge of the Gaze, connecting them to the upper and lower spreaders when assembled.
Run your dual line kites hard or still learning how to fly? The Gaze is tough but to be prepared for anything, use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. Recommendations below!
Package includes four aluminum end caps, four washer sets (8 pieces), four bungees (6” each) and two 4" cable ties, all you need to replace all four wingtips of a Djinn.
Reviews
There are no reviews yet.