Weight | .2 oz |
---|---|
Dimensions | 1 × 1 × 1 in |
Vinyl End Caps | 6mm (Gaze STD Upper LE), 8mm (Gaze STD Spine) |
Additional information
Reviews (0)
Related products
Unique Yo Yo Stopper used on the Gaze leading edge, complete with one zip tie - designed to allow solid roll up tricks, additional notches allow a little forgiveness for overly slack lines.
T fitting used at the bottom of the Gaze spine, complete with 15g + 5g weights.
Run your Djinn hard or just learning how to fly? Use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. **
Run your dual line kites hard or still learning how to fly? The Gaze is tough but to be prepared for anything, use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. Recommendations below!
One set of three replacement Sync Bridle pigtails for the Djinn quad line kite, includes one center and two shoulder pieces that attach to the leading edge, these components take the most abuse (ground abrasion) and are also the easiest to replace.
Replacement carbon spars for the Djuice quad line kite (ST = D12 or VT = D15), each spar measures 31" in length and does not include ferrules... If you are ordering spare rods, be sure to also add 2 Dynamic ferrules for every 5 spars to make a complete frame - for the Djuice, ferrules are located in one end of the right and left wing spars.
This product has multiple variants. The options may be chosen on the product pageCenter T fitting used the bottom spreaders of the Gaze connect with the spine when assembled.
One ferrule, solid fiberglass joint used to connect the Mystic spars in a Djinn leading edge.
This product has multiple variants. The options may be chosen on the product page
Reviews
There are no reviews yet