Yo Yo Stopper (Claw)
$2.50
Unique Yo Yo Stopper used on the Gaze leading edge, complete with one zip tie – designed to allow solid roll up tricks, additional notches allow a little forgiveness for overly slack lines.
Additional information
| Weight | .3 oz |
|---|---|
| Dimensions | 5 × 1 × 1 in |
Reviews (0)
Related products
One ferrule, solid fiberglass joint used to connect the Mystic spars in a Djinn leading edge.
This product has multiple variants. The options may be chosen on the product page
Package includes four aluminum end caps, four washer sets (8 pieces), four bungees (6” each) and two 4" cable ties, all you need to replace all four wingtips of a Djinn.
One ferrule, the joint used to connect the Radius spars in the Gaze leading edge (8cm) or bottom spreaders (12cm).
This product has multiple variants. The options may be chosen on the product page
Built for our most active customers, the L3 Clips are designed for use at the three Sync Bridle points which may see wear on the leading edge material of either the Djinn or Djuice with aggressive use. Once installed, the leading edge spar can still slide through easily with the bridle and leading edge material fully protected in those areas. These will also fit most other quad line kites with similar bridle attachments (frequently the center point). Check out the installation tutorial below!
This product has multiple variants. The options may be chosen on the product page
Fittings for the bottom spreaders of the Gaze, connecting them to the stand offs when assembled. Sold individually.
Run your dual line kites hard or still learning how to fly? The Gaze is tough but to be prepared for anything, use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. Recommendations below!
Extremely well suited to kite applications where rod and ferrule experience repeated torque situations, IC-2000™ is a rubber-toughened cyanoacrylate that forms superior shock resistant bonds on non-porous surfaces.
Package includes four plastic end caps, four washers, four bungees (6” each) and two 4" cable ties, all you need to replace all four wingtips of a Djuice.
Reviews
There are no reviews yet