Gaze Framing
$2.50 – $15.00
Replacement carbon spars for each frame component of the Gaze dual line kite, all pre-cut for easy installation.
Description
Gaze STD Frame
- Leading Edge: Radius L (pre-cut)
- Bottom Spreaders: Radius R (pre-cut)
- Spine: Mystic 14 (pre-cut, 2 pieces ferruled)
- Top Spreader: 6mm carbon (pre-cut)
- Stand Offs: 3mm carbon (pre-cut, complete)
Fitting Guide (parts can be found here)
Most breakages in the field allow you to simple swap over the existing fittings onto replacement rods but if you wish to make a ready to install spare for your kite bag, these are the accompanying fittings for each spar:
- Leading Edge
Upper – 1x Radius ferrule (8cm), 1x upper spreader APA, 1x c-clip stopper, 1x vinyl end cap (6mm), 1x yo yo stopper (claw), 1x zip tie.
Lower – 1x lower spreader APA, 2x c-clip stoppers, 1x wing tip spike. - Bottom Spreaders – 1x Radius ferrule (12cm) between two spreaders (glued into one side), 2x stand off fittings on each bottom spreader.
- Spine – 1x center T fitting, 1x tail weight fitting, 2x c-clip stoppers, 1x vinyl end cap (8mm).
Additional information
| Weight | .60 oz |
|---|---|
| Dimensions | 31 × .5 × .5 in |
| Spar Options | STD Leading Edge – Radius L (29.5"), STD Bottom Spreader – Radius R (28.25"), STD Spine – Mystic 14 (35.75"), STD Top Spreader – 6mm Carbon (20.75"), STD Stand Off – 3mm Carbon (10") |
Reviews (0)
Related products
Spike (or "nock") end cap used on the wing tip of the Gaze, complete with tensioner line - designed to provide good tip stabs even on firm earth or hard packed sand.
Vinyl end caps for the nose-end of the Gaze spine and upper leading edge spars.
This product has multiple variants. The options may be chosen on the product page
One ferrule, the joint used to connect the Radius spars in the Gaze leading edge (8cm) or bottom spreaders (12cm).
This product has multiple variants. The options may be chosen on the product page
T fitting used at the bottom of the Gaze spine, complete with 15g + 5g weights.
Replacement carbon spars for the Djuice quad line kite (ST = D12 or VT = D15), each spar measures 31" in length and does not include ferrules.
This product has multiple variants. The options may be chosen on the product page
Run your dual line kites hard or still learning how to fly? The Gaze is tough but to be prepared for anything, use this page to easily assemble your basic "ready for anything" package includes everything that could potentially and naturally break or wear out on the kite with a bad crash or extended use. Recommendations below!
One 4" ferrule, solid fiberglass joint used to connect the Dynamic spars in a Djuice leading edge.
Package includes four plastic end caps, four washers, four bungees (6” each) and two 4" cable ties, all you need to replace all four wingtips of a Djuice.
Reviews
There are no reviews yet